A4988 Driver Stepper

$3.00

The A4988 is a complete Microstepping Motor Driver with built-in translator for easy operation. The driver has a maximum output capacity of 35 V and ± 2 A. It can operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes.

SKU: N/A Category: Tags: , ,

Description

The A4988 is a complete Microstepping Motor Driver with built-in translator for easy operation. The driver has a maximum output capacity of 35 V and ± 2 A. It can operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes.

Pinout

Pin Name Description
VDD & GND Connected to 5V and GND of Controller
VMOT & GND MOT Used to power the motor
1A, 1B & 2A, 2B Output Pins, Connected to the 4 Wires of motor
DIRECTION Motor Direction Control pin
STEP Steps Control Pin
MS1, MS2, MS3 Microstep Selection Pins
FAULT Fault Detection Pin
SLEEP Pins For Controlling Power States
ENABLE Enable module to ready run motor
RESET Reset module

Additional information

Color

Green, Red

Technical Specification

Operating Voltage 8V to 35V
Max Current per Phase 2A
Output Current Adjustable output current via potentiometer
Six step resolution Full step, ½ step, ¼ step, 1/8 step, 1/16 step
Revers Voltage Protection No
Protection Short-to-ground and shorted-load protection
Thermal Protection Thermal shutdown circuitry
PBC Size 15.5 mm x 20.5 mm

Download

Reviews

There are no reviews yet.

Add a review

Your email address will not be published. Required fields are marked *

You may also like…

  • $3.00

    The CNC Shield v4 is made for the control of 3D printers, milling and engraving machines. This version of the shield has 1 motor driver less than its predecessor, but is more compact and has room for an Arduino Nano. This board has 3 sockets for the installation of stepper motor drivers such as the A4988. Only 2 channels per motor are required to control this motor. There is also a connection for 2 end-stop switches per motor.

  • Out of Stock
    $3.00

    CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.

A4988 Driver Stepper

Add to cart