HC-SR501 PIR Motion Sensor

$2.50

Available on backorder

Add to wishlist
Categories: , , Tags: ,

Description

HC-SR501 PIR Motion Sensor

HC-SR501 is an electronic motion sensor that uses a passive infrared light sensing to detect any movement of an object, an animals or a person. HC-SR501 only sends positive or negative results so it is mainly used in security alarms and automatic lighting systems, and it is compatible with Raspberry Pi and Arduino. HC-SR501 motion sensor has two adjustable knobs: Tx knob adjust the detection delay and Sx adujsts the range from 3 to 5 meters.

HC-SR501 Motion Sensor Features

  • Operating Voltage: 5-12V
  • Logic Signal Voltage: 3.3V
  • Detection Range: 3-5 meters
  • Detection Angle: 140º
  • Hold Time: 5-200 seconds
  • Dimensions: 33x25x24 (mm)

Using HC-SR501 PIR Motion Sensor with Arduino - YouTube

Reviews

There are no reviews yet.

Add a review

Your email address will not be published. Required fields are marked *

Related products

  • Out of Stock
    Add to wishlist
    Read more Quick View

    LCD OLED 0.96″ White 7pins

    $6.00

    The OLED displays are one of the most attractive displays available for a microcontroller. It has a good view angle and pixel density which makes it reliable for displaying small level graphics. Interfacing this IC with MCU can either be done using IIC or using SPI hence helps to save some pins as well.

    So if you are looking for a slim, attractive and efficient display module to make your project look cool with graphics then this module might be the right choice for you.

    Read more
  • Add to wishlist
    Select options Quick View

    L293D Motor Shield

    $3.00 – $3.50

    These shield is made by L293D driver chip. It is very easy for plug with Arduino or ESP to drive any DC motor for Robot or RC Car.

    Select options
    Clear
  • Add to wishlist
    Select options Quick View

    Arduino UNO R3

    $6.00 – $8.50

    Arduino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator (CSTCE16M0V53-R0), a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your Uno without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

    Select options
  • Add to wishlist
    Select options Quick View

    HC-Bluetooth

    $6.00 – $7.50

    Each Model of HC Bluetooth is very popular for using with any Microcontroller such as Arduino or STM. Bluetooth is easy for you to control wirelessly any device in short rang via your Phone or Computer. Bluetooth model of HC have communication protocol UART.

    Select options

HC-SR501 PIR Motion Sensor

$2.50

Available on backorder