The RC522 is a 13.56MHz RFID module that is based on the MFRC522 controller from NXP semiconductors. The module can supports I2C, SPI and UART and normally is shipped with a RFID card and key fob. It is commonly used in attendance systems and other person/object identification applications.
RFID MFRC-522 RC522 Module
$5.00
5 in stock
Description
The RC522 is a 13.56MHz RFID module that is based on the MFRC522 controller from NXP semiconductors. The module can supports I2C, SPI and UART and normally is shipped with a RFID card and key fob. It is commonly used in attendance systems and other person/object identification applications.
Pinout
| Pin Number | Pin Name | Description |
| 1 | Vcc | Used to Power the module, typically 3.3V is used |
| 2 | RST | Reset pin – used to reset or power down the module |
| 3 | Ground | Connected to Ground of system |
| 4 | IRQ | Interrupt pin – used to wake up the module when a device comes into range |
| 5 | MISO/SCL/Tx | MISO pin when used for SPI communication, acts as SCL for I2c and Tx for UART. |
| 6 | MOSI | Master out slave in pin for SPI communication |
| 7 | SCK | Serial Clock pin – used to provide clock source |
| 8 | SS/SDA/Rx | Acts as Serial input (SS) for SPI communication, SDA for IIC and Rx during UART |
Technical Specification
| Module | 13.56MHz RFID |
| Operating Voltage | 2.5V to 3.3V |
| Communication | SPI, I2C protocol, UART |
| Maximum Data Rate | 10Mbps |
| Read Range | 5cm |
| Current Consumption | 13 to 26mA |
| Power down mode consumption | 10uA (min) |
Download
Related products
-
$1.25The module (MicroSD Card Adapter) is a Micro SD card reader module, through the file system and the SPI interface driver, SCM system to complete the file to read and write MicroSD card. Arduino users can directly use the Arduino IDE comes with an SD card to complete the library card initialization and read
-
$7.50PN532 is NFC RFID (Radio Frequency Identification) module. This module is built around NXP PN532 IC. NXP PN532 IC is very popular in NFC applications.
-
$3.00The A4988 is a complete Microstepping Motor Driver with built-in translator for easy operation. The driver has a maximum output capacity of 35 V and ± 2 A. It can operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes.
-
Out of Stock
$5.00The LilyPad Arduino is designed for e-textiles and wearables projects. It can be sewn to fabric and similarly mounted power supplies, sensors and actuators with conductive thread.
5 in stock
Reviews
There are no reviews yet.