SIM800A_ Nano development board is a high-performance industrial-grade GSM/GPRS module with a rich interface, perfect function, stable operation, strong anti-interference, high integration of peripheral circuits and small size. It is especially suitable for various fields that require voice/SMS/GPRS data services, such as smart home, intelligent collection system, remote monitoring and so on.
Features:
Support dual-band GSM/GPRS (900MHz / 1800MHz)
Support RS232/TTL serial port (supports 3. 3V/5V system)
Support 5V- 18V power supply (9V1A power supply is recommended)
Reserved voice interface
Reserve SMA and IPX interfaces
Support SMS service MT/M0/Text/PDU mode
Support TCP/UDP communication, FTP/HTTP service
Support Nano SIM card
Pin description:
PWR: Positive power supply
DTR: DTR
RI: RI output pin
RES: reset foot
M+: Mic+
M-: Mic-
S+: horn positive
S-: horn negative
GND: power ground
BAT: Lithium battery power supply interface
EN: Power enable, default high
VCC_IN: external power input
TXD: TTL serial output
RXD: TTL serial input
V_MCU: Level matching interface
R_232: RS232 serial input
T_232: RS232 serial output
SIM800A Chip:
Main Characteristics:
Two-frequency 900/1800MHz
GPRS multi-slot class 12/10
GPRS m0bile station class B
Meet the GSM 2/2+ standard
– Class 4 (2W @900MHz)
– Class 1 (1W @1800MHz)
Size: 24*24*3mm
Controlled by AT c0mmands (GSM 07.07, 07.05 and SIMCOM enhanced AT c0mmand set)
Supply voltage: 3.4 ~ 4.4V
Low power consumption
Operating temperature: -40°C ~ +85°C
Data Transmission:
GPRS class 12: Maximum 85.6 kbps (downstream rate)
The RC522 is a 13.56MHz RFID module that is based on the MFRC522 controller from NXP semiconductors. The module can supports I2C, SPI and UART and normally is shipped with a RFID card and key fob. It is commonly used in attendance systems and other person/object identification applications.
Arduino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator (CSTCE16M0V53-R0), a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your Uno without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.
Module is used where short distance wireless communication is needed. The module is used for wireless communications of less than 100 meters. The module is preferred where power consumption is issue. HM-10 MODULE is designed by BLE chip so it consumes very less power to function. So the module can be used on mobile systems. The module uses UART communication and so it can be interfaced with almost all controllers or processors.
Reviews
There are no reviews yet.