SIM800A_ Nano development board is a high-performance industrial-grade GSM/GPRS module with a rich interface, perfect function, stable operation, strong anti-interference, high integration of peripheral circuits and small size. It is especially suitable for various fields that require voice/SMS/GPRS data services, such as smart home, intelligent collection system, remote monitoring and so on.
Features:
Support dual-band GSM/GPRS (900MHz / 1800MHz)
Support RS232/TTL serial port (supports 3. 3V/5V system)
Support 5V- 18V power supply (9V1A power supply is recommended)
Reserved voice interface
Reserve SMA and IPX interfaces
Support SMS service MT/M0/Text/PDU mode
Support TCP/UDP communication, FTP/HTTP service
Support Nano SIM card
Pin description:
PWR: Positive power supply
DTR: DTR
RI: RI output pin
RES: reset foot
M+: Mic+
M-: Mic-
S+: horn positive
S-: horn negative
GND: power ground
BAT: Lithium battery power supply interface
EN: Power enable, default high
VCC_IN: external power input
TXD: TTL serial output
RXD: TTL serial input
V_MCU: Level matching interface
R_232: RS232 serial input
T_232: RS232 serial output
SIM800A Chip:
Main Characteristics:
Two-frequency 900/1800MHz
GPRS multi-slot class 12/10
GPRS m0bile station class B
Meet the GSM 2/2+ standard
– Class 4 (2W @900MHz)
– Class 1 (1W @1800MHz)
Size: 24*24*3mm
Controlled by AT c0mmands (GSM 07.07, 07.05 and SIMCOM enhanced AT c0mmand set)
Supply voltage: 3.4 ~ 4.4V
Low power consumption
Operating temperature: -40°C ~ +85°C
Data Transmission:
GPRS class 12: Maximum 85.6 kbps (downstream rate)
The OLED displays are one of the most attractive displays available for a microcontroller. It has a good view angle and pixel density which makes it reliable for displaying small level graphics. Interfacing this IC with MCU can either be done using IIC or using SPI hence helps to save some pins as well.
So if you are looking for a slim, attractive and efficient display module to make your project look cool with graphics then this module might be the right choice for you.
CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
The CNC Shield v4 is made for the control of 3D printers, milling and engraving machines. This version of the shield has 1 motor driver less than its predecessor, but is more compact and has room for an Arduino Nano. This board has 3 sockets for the installation of stepper motor drivers such as the A4988. Only 2 channels per motor are required to control this motor. There is also a connection for 2 end-stop switches per motor.
Reviews
There are no reviews yet.