Voltage Detection Sensor 25V Module

$0.50

Available on backorder

Description

Voltage Detection Sensor Module 25V module is based on the principle of resistive voltage divider design, it can make the red terminal connector input voltage to 5 times smaller. Arduino analog input voltages up to 5 v. The voltage detection module input voltage not greater than 5Vx5=25V (if using 3.3V systems, input voltage not greater than 3.3Vx5=16.5V).

It has the limit of Arduino analog input  5 VDC only. So if you wish to measure higher voltages,  you will need to resort to another means.  One way is to use a voltage divider.  It is fundamentally a 5:1 voltage divider using a 30k and 1 7.5k ohm resistor.

Note: Keep in mind, you are restricted to voltages that are less than 25 volts.   More than that and you will exceed the voltage limit of your Arduino input.

Features:-

  • Voltage input range: DC 0-25V
  • Voltage detection range: DC 0.02445V-25V
  • Voltage Analog Resolution: 0.00489V
  • DC input connector: Terminal cathode connected to VCC, GND negative pole
  • Output interface: “+” connect 5/3.3V, “-” connect GND, “s” connect the Arduino AD pins

Specifications:

  • Dimensions: 28 x 14 x 13 mm .
  • Weight: 4 gm.
  • Input Voltage range: DC0 to 25 V
  • Voltage detection range: DC 0.02445 V to 25 V
  • Analog Voltage resolution : 0.00489 V
  • Output Interface : “+ ” connected 5/3.3V, “-” connected GND, “s” connected Arduino AD pins
  • DC input interface: red terminal positive with VCC, negative with GND
  • You can also use the IICLCD1602 LCD to display voltage.
  • By 3P connector, connect this module with the expansion of board Arduino, not only makes it easier for you to detect voltage battery.

INPUT:

  • GND –  This is where you connect the low side of the voltage you are measuring.   * Caution:  This is the same electrical point as your Arduino ground.
  • VCC –  The is where you connect the high side of  the voltage you are measuring (0 – 25V)

OUTPUT:

  • S:  This connects to your Arduino analog input.
  • – (or minus):  This connects to your Arduino ground.
  • +:  This is not connected.  It does absolutely nothing.
  • Buy 25V Voltage Detector Sensor Module at Low Price In India

Reviews

There are no reviews yet.

Add a review

Your email address will not be published. Required fields are marked *

Voltage Detection Sensor 25V Module

$0.50

Available on backorder