XBee Module Series upgrade S2 Zigbee Wireless Data Transmission Module

$30.00

Available on backorder

Description

Items Description

XBee S2C Wire 6.3mW
1200 meters of wireless data transmission module
Fully compatible with the replacement XBEE S2
Brief introduction:
Xbee module is a ZigBee wireless module technology, such as through inter serial devices to communicate with the microcontroller , can very quickly achieve the purpose of the device is connected to a ZigBee network.
This is a new Digi produced 2.4Ghz Xbee XB24-Z7WIT-004 wireless transmission module. Improved versions of the output power and transport protocols. S2 series and basic models have the same pin definitions , but stronger output power -2mW. Its maximum transmission distance up to 1200 meters ( outdoor open distance ) and transfer rates of up to 250kbps . This module provides a highly reliable data transfer , any serial output devices can use the module for data transfer, support point – point and multi-point network transmission .
Technical Specifications
3.3V @ 40mA
250kbps Max data rate
2mW output (+ 3dBm)
400ft (120m) range
Built-in Antenna
By FCC certification
6 10-bit ADC input pins
8 Data IO interface
128-bit encryption
Local or over-air configuration
AT or API command set
Description:
This is the XBee XB24-Z7WIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.
These are essentially the same hardware as the older Series 2.5, but have updated firmware. They will work with Series 2.5 modules if you update the firmware through X-CTU.
Not sure which XBee module or accessory is right for you? Check out our XBee Buying Guide!
Note: If you are looking for a simple point-to-point configuration, you might want to try the Series 1 instead The Series 2 requires considerable setup and configuration We highly recommendBuilding Wireless Sensor Networks as a guide for setting up mesh networks…
Note:. Series 1 and Series 2 XBee modules have the same pin-out However, Series 1 modules can not communicate with Series 2 modules.
Note: If you are using these outside of the United States, please check with your local laws regarding radio communication.
Features:
3.3V @ 40mA
250kbps Max data rate
2mW output (+ 3dBm)
400ft (120m) range
Built-in antenna
Fully FCC certified
6 10-bit ADC input pins
8 digital IO pins
128-bit encryption
Local or over-air configuration
AT or API command set

Reviews

There are no reviews yet.

Add a review

Your email address will not be published. Required fields are marked *

XBee Module Series upgrade S2 Zigbee Wireless Data Transmission Module

$30.00

Available on backorder