-
-
-
-
-
$2.50This MQ-2 smoke and gas detector is used to detect smoke and combustible gases including hydrogen, methane, butane, alcohol and liquid propane gas (LPG). Suitable for home and industrial use, it has fast response and recovery characteristics, long life and reliable stability. The module features dual signal outputs: An analog […]
-
-
$5.70INA219 DC Current Sensor Module Breakout Board I2C 26V 1. The programmable calibration register can be read in amps of DC and power in watts. 2. Up to 128 samples can be averaged to achieve filtering in a noisy environment. 3. The I2C interface has a timeout setting, which can […]
-
-
-
-
$2.50Features Double-sided tape on the back of the breadboard White, for a professional appearance (not transparent) 1 Terminal Strip, 630 Tie-points 2 Distribution Strips, 200 Tie-points Size 16.5×5.4×0.85 (cm) Coloured coordinates for easy component placement Accepts a variety of wire sizes (AWG:20-29) Excellent for DIY projects, prototyping and experimenting
-
$2.00DS3231 AT24C32 IIC Module Precision Real Time Clock with Battery CR2032 Module parameters: 1 Size: 38mm (length) * 22mm (W) * 14mm (height) 2 Weight: 8g 3 Operating voltage :3.3 – 5 .5 V 4 clock chip: high-precision clock chip DS3231 5 Clock Accuracy :0-40 ° range, the accuracy 2ppm, […]
-
$6.00 – $8.50Arduino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator (CSTCE16M0V53-R0), a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your Uno without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.
-
-
$1.25Infrared Emission Module IR Transmitter Module This infrared transmitter module is basically a breakout board for an infrared LED with a few other passive components on the board. It includes a series current limiting resistor for the IR LED and a surface mount indication LED with it’s own current limiting […]
-
$3.00HX711 Module Load Cell Voltage Amplifier HX711 features dual-channel 24 Bit Precision A/D Weight Pressure Sensor Load Cell Amplifier which is available in a small breakout board. The board has pinouts for the microcontroller and the Load cell in two different directions for the ease of interfacing. It can be […]
-
$1.25Specifications: Circuit board B- connects power negatively, B+ connects positive. Don’t inversely connect, it will result in the burning of the board. Make sure there is insulation between power and circuit when installing the battery 1A output is not continuous current, it changes according to USB connecting load, automatic current […]
-
$5.00EMAX ES08A II Mini Plastic Gear Servo 60 Degree 1.8Kg-sec For RC Models and Robotic
-
-
Concept
Bridge Cable Robot
Cable Inspection Robot is a research project by ArrowDot Company with function to check the quality of cable for bridge which can be used for Neak Loeung Bridge, New Balay Bridge and planned Koh Pich-Koh Norea Bridge. This robot equipped with analyzed camera that can view the cracked point and the vibration level of the cable. Last but not least, this robot can be remote and live up to 500m wirelessly.
