Description
Open-build V Gantry Plate 2020 V-Slot Aluminum Profile Slider Plate with Buckle Pulley
CNC Part
3D Printer
Wheel Roller
Open-build V Gantry Plate 2020 V-Slot
$7.00
Available on backorder
Related products
-
Out of Stock
$6.00Module is used where short distance wireless communication is needed. The module is used for wireless communications of less than 100 meters. The module is preferred where power consumption is issue. HM-10 MODULE is designed by BLE chip so it consumes very less power to function. So the module can be used on mobile systems. The module uses UART communication and so it can be interfaced with almost all controllers or processors.
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$3.00The A4988 is a complete Microstepping Motor Driver with built-in translator for easy operation. The driver has a maximum output capacity of 35 V and ± 2 A. It can operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes.
Select options This product has multiple variants. The options may be chosen on the product page -
Out of Stock
$3.00CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$15.00 – $16.50The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Mega 2560 board is compatible with most shields designed for the Uno and the former boards Duemilanove or Diecimila.
Select options This product has multiple variants. The options may be chosen on the product page
Available on backorder
Reviews
There are no reviews yet.