Description
SH 1.0mm Wire Cable Connector Single Head Female 10CM
SH 1.0mm Wire Cable Connector Single Head Female 10CM
$0.19 – $1.03
Additional information
| SH 1.0mm | 2pins, 3pins, 4pins, 5pins, 6pins, 7pins, 8pins, 9pins, 10pins, 12pins |
|---|
Related products
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$6.00 – $7.50Each Model of HC Bluetooth is very popular for using with any Microcontroller such as Arduino or STM. Bluetooth is easy for you to control wirelessly any device in short rang via your Phone or Computer. Bluetooth model of HC have communication protocol UART.
Select options This product has multiple variants. The options may be chosen on the product page -
Select options This product has multiple variants. The options may be chosen on the product page Quick View$12.00Select options This product has multiple variants. The options may be chosen on the product page -
Out of Stock
$6.00Module is used where short distance wireless communication is needed. The module is used for wireless communications of less than 100 meters. The module is preferred where power consumption is issue. HM-10 MODULE is designed by BLE chip so it consumes very less power to function. So the module can be used on mobile systems. The module uses UART communication and so it can be interfaced with almost all controllers or processors.
-
Out of Stock
$3.00CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
Reviews
There are no reviews yet.