Description
CNC Part
3D Printer
3D Print Part
Slide Screw
Linear
T8 Lead Screw 8mm Pitch 2mm with Brass Nut Roll Linear
$1.00 – $8.00
Additional information
| T8 Lead Screw | T8*10CM + Brass Nut, T8*15CM + Brass Nut, T8*20CM + Brass Nut, T8*25CM + Brass Nut, T8*30CM + Brass Nut, T8*35CM + Brass Nut, T8*40CM + Brass Nut, T8*45CM + Brass Nut, T8*50CM + Brass Nut, T8*100CM + Brass Nut |
|---|
Related products
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$6.00 – $7.50Each Model of HC Bluetooth is very popular for using with any Microcontroller such as Arduino or STM. Bluetooth is easy for you to control wirelessly any device in short rang via your Phone or Computer. Bluetooth model of HC have communication protocol UART.
Select options This product has multiple variants. The options may be chosen on the product page -
$7.50PN532 is NFC RFID (Radio Frequency Identification) module. This module is built around NXP PN532 IC. NXP PN532 IC is very popular in NFC applications.
-
Out of Stock
$3.00CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$6.00 – $8.50Arduino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator (CSTCE16M0V53-R0), a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your Uno without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.
Select options This product has multiple variants. The options may be chosen on the product page
Reviews
There are no reviews yet.