-
$6.00Ramps 1.6 is optimized and launched based on Ramps 1.4 & Ramps 1.5 The Struture almost same as Ramps 1.5 , the difference is Ramps 1.6 have new 2pin connectors,which more simple and convenient to connect,also will not be burnt easily,what’s more ,Ramps 1.6 have a good Heatsink above MOS […]
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$2.75 – $4.50IP68 Waterproof TS13-2pins IP68 Waterproof TS13-3pins IP68 Waterproof TS13-4pins IP68 Waterproof TS13-5pins IP68 Waterproof TS17-2pins IP68 Waterproof TS17-3pins IP68 Waterproof TS17-4pins IP68 Waterproof TS17-5pins
Select options This product has multiple variants. The options may be chosen on the product page -
$3.00Microcontroller Features 20 MHz Max. CPU Speed 35 Instructions 8 Level Hardware Stack 8 MHz Internal Oscillator – Selectable Output Range from 8 MHz to 31 kHz 24 I/O Pins – PIC16F882/883/886 35 I/O Pins – PIC16F884/887 Power-On Reset (POR) Brown-Out Reset (BOR) Power-Up Timer (PWRT) Oscillator Start-Up Timer […]
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$8.50Features: It can protect the charging batteries when short circuit happens. It can support combined use for three parallel charging boards (means you can charge eighteen batteries which have the same characters simultaneously). It has 2OZ-thick copper foil, so it can withstand continual current of 80A. It can prevent each […]
Select options This product has multiple variants. The options may be chosen on the product page -
$0.75This is ULN2003 Driver Module Stepper Motor Driver Board for driving and controlling stepper motors. ULN2003 Stepper Motor Driver Board uses the ULN2003 DARLINGTON ARRAYS to drive the 4-phase 5-wire stepper motor (5v-12v). It’s easy to use Arduino or another development platform to drive the stepper motor by this diver board. […]
-
-
$0.50DESCRIPTION Low Cost Small DC Motor SPECIFICATION Model: R140 Operating Voltage: 3 – 6VDC Diameter: 21mm Shaft diameter: 2mm Shaft Length: 9mm No load RPM:12000 (3V) No load current: 0.22A Stall Torque: 78 g.cm Size: 40 x 21 mm
-
$3.00Dual Motor Driver Module 1A TB6612FNG Max 15V 1A Microcontroller for Arduino The TB6612FNG Motor Driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes: […]
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$1.25 – $4.00Copper Clad Sheet PCB Laminate DIY Circuit Board PCB Single A4 A5 PCB Double A4 A5
Select options This product has multiple variants. The options may be chosen on the product page -
$0.50CH340G USB to Serial Converter chip is being used in various devices to convert the USB Interface to UART signal, for connection with MCU. It supports Full Speed USB 2.0. And it sports a Full Duplex Serial UART Interface, and supports baud rate from 50 bps to 2 Mbps. This […]
-
$4.00Description: Water flow sensor consists of a plastic valve bodya water rotorand a hall-effect sensor. When water flows through the rotorrotor rolls. Its speed changes with different rate of flow. The hall-effect sensor outputs the corresponding pulse signal. This one is suitable to detect flow in water dispenser or coffee […]
-
$0.632040 Corner Fitting Angle Aluminum L Bracket Double Standard 2020 & 2040 Aluminum Profile
-
$4.50Adjustable Step Down Converter Module with Voltmeter Parameters 1. Input voltage range:4~38 V (Note:input voltage not exceeding 38V) 2. Output :1.25-36V Adjustable 0-5A 3. Output power: 75W 4. Voltmeter range: 4 to 40V, error ±0.1V 5. Operating frequency: 180KHz 6. High efficiency up to 96% 7. Built in thermal […]
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$0.38 – $0.63Single Phase Bridge Rectifier Diodes 1000V 4Pins
Select options This product has multiple variants. The options may be chosen on the product page -
Select options This product has multiple variants. The options may be chosen on the product page Quick View$4.00 – $15.00Single Phase Solid State Relay SSR MGR-1 Controller Voltage DC 3-34V Switch Output 24-480V Solid state relay (SSR) abbreviations electronic non-contact switch, the main characteristics of tiny control input signal, the direct drive high current load. Product is used widely, advantages: long life, non-contact, no spark, no noise, no electromagnetic […]
Select options This product has multiple variants. The options may be chosen on the product page -
$20.00Items Description Three power input interface: DC044 interface and V_IN and a lithium battery interface. Note that: The range of DC044 and the V_IN pin voltage input is 5 – 26V, when use the 5V as the power, be sure that the power supply can provide 2A current. The range […]
-
$15.00This is a DC-DC constant current boost converter power supply module with DC 10-60V voltage input and DC 12V-83V output voltage. The input and output of the module are designed with screw terminals for convenient wire connection or disconnection. Besides, it is equipped with a big heat sink and cooling […]
-
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$0.2010 pcs lots LED 2X5X7mm Flat
Select options This product has multiple variants. The options may be chosen on the product page -
Concept
Bridge Cable Robot
Cable Inspection Robot is a research project by ArrowDot Company with function to check the quality of cable for bridge which can be used for Neak Loeung Bridge, New Balay Bridge and planned Koh Pich-Koh Norea Bridge. This robot equipped with analyzed camera that can view the cracked point and the vibration level of the cable. Last but not least, this robot can be remote and live up to 500m wirelessly.
