PWM Control Motor 400W 12-40V 10A

$4.00

Available on backorder

Add to wishlist
Categories: , ,

Description

SPECIFICATION

  • Input voltage: DC 12V-40V, power: 0.01-400W, current: rated current 8A, large through current 10A, quiescent current 0.02A (standby state), frequency: 13khz, PWM pulse width speed regulation range: 10%-100%.
  • Equipped with 10A fuse, with power supply reverse connection, control voltage overvoltage protection function, equipped with high-quality potentiometer, suitable for DC motor speed control.
  • 50V1000uF large capacitor, compared with other types of speed regulators, the capacitance value of 100-220uF has obvious advantages.
  • If you need the forward and reverse function, you can connect the positive and negative switch by yourself.
  • The power tube uses IRF3205, which is a big cow, and there is absolutely no need to worry about not being able to drive your motor. (Maximum value of parameter drain current Id: 82A; maximum voltage Vds: 75V; on-state resistance, Rds(on): 0.013ohm).

Reviews

There are no reviews yet.

Add a review

Your email address will not be published. Required fields are marked *

Related products

  • Add to wishlist
    Select options This product has multiple variants. The options may be chosen on the product page Quick View

    A4988 Driver Stepper

    $3.00

    The A4988 is a complete Microstepping Motor Driver with built-in translator for easy operation. The driver has a maximum output capacity of 35 V and ± 2 A. It can operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes.

    Select options This product has multiple variants. The options may be chosen on the product page
    Clear
  • Add to wishlist
    Select options This product has multiple variants. The options may be chosen on the product page Quick View

    Arduino MEGA 2560

    $15.00 – $16.50

    The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Mega 2560 board is compatible with most shields designed for the Uno and the former boards Duemilanove or Diecimila.

    Select options This product has multiple variants. The options may be chosen on the product page
  • Add to wishlist
    Add to cart Quick View

    CNC Shield V4 for Nano

    $3.00

    The CNC Shield v4 is made for the control of 3D printers, milling and engraving machines. This version of the shield has 1 motor driver less than its predecessor, but is more compact and has room for an Arduino Nano. This board has 3 sockets for the installation of stepper motor drivers such as the A4988. Only 2 channels per motor are required to control this motor. There is also a connection for 2 end-stop switches per motor.

    Add to cart
  • Add to wishlist
    Select options This product has multiple variants. The options may be chosen on the product page Quick View

    L293D Motor Shield

    $3.00 – $3.50

    These shield is made by L293D driver chip. It is very easy for plug with Arduino or ESP to drive any DC motor for Robot or RC Car.

    Select options This product has multiple variants. The options may be chosen on the product page
    Clear

PWM Control Motor 400W 12-40V 10A

$4.00

Available on backorder