Each Model of HC Bluetooth is very popular for using with any Microcontroller such as Arduino or STM. Bluetooth is easy for you to control wirelessly any device in short rang via your Phone or Computer. Bluetooth model of HC have communication protocol UART.
Description
Each Model of HC Bluetooth is very popular for using with any Microcontroller such as Arduino or STM. Bluetooth is easy for you to control wirelessly any device in short rang via your Phone or Computer. Bluetooth model of HC have communication protocol UART. HC-05 and HC-06 is a version Bluetooth 2.1 which can use with only Phone or PC that support 2.0 Bluetooth while HC-08 is BLE which can use with modern Phone and PC such as Mac.
Additional information
| Bluetooth Model | HC-05, HC-06, HC-08 |
|---|---|
| Module Type | Breakout, Non Breakout |
Technical Specification
- Pinout for HC-05 and HC-06
| Pin Number | Pin Name | Description |
| 1 | Enable / Key | This pin is used to toggle between Data Mode (set low) and AT command mode (set high). By default it is in Data mode |
| 2 | Vcc | Powers the module. Connect to +5V Supply voltage |
| 3 | Ground | Ground pin of module, connect to system ground. |
| 4 | TX – Transmitter | Transmits Serial Data. Everything received via Bluetooth will be given out by this pin as serial data. |
| 5 | RX – Receiver | Receive Serial Data. Every serial data given to this pin will be broadcasted via Bluetooth |
| 6 | State | The state pin is connected to on board LED, it can be used as a feedback to check if Bluetooth is working properly. |
| 7 | LED | Indicates the status of Module
|
| 8 | Button | Used to control the Key/Enable pin to toggle between Data and command Mode |
- Specification for HC-08
| Pin | Name | Function |
| 1 | Key | The pin state use to wake up module from sleep mode or disconnect from remote device or reset to default configuration then restart.
Prese Low >= 1000ms |
| 2 | Vcc | +5V Positive supply needs to be given to this pin for powering the module |
| 3 | Gnd | Connect to ground |
| 4 | TXD | Serial data is transmitted by module through this pin (at 9600bps by default), 3.3V logic |
| 5 | RXD | Serial data is received by module through this pin (at 9600bps by default),3.3V logic |
| 6 | State | The pin is connected to the LED on the board to represent the state of the module |
Download
Related products
-
$6.00 – $7.00NodeMCU is an open-source Lua based firmware and development board specially targeted for IoT based Applications. It includes firmware that runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which is based on the ESP-12 module.
-
Out of Stock
$5.00The LilyPad Arduino is designed for e-textiles and wearables projects. It can be sewn to fabric and similarly mounted power supplies, sensors and actuators with conductive thread.
-
$1.25The module (MicroSD Card Adapter) is a Micro SD card reader module, through the file system and the SPI interface driver, SCM system to complete the file to read and write MicroSD card. Arduino users can directly use the Arduino IDE comes with an SD card to complete the library card initialization and read
-
$3.50The DRV8825 is a Motor Driver with two H-bridge drivers and a microstepping indexer. The driver has a maximum output capacity of 45 V and ± 2.5 A. It can operate bipolar stepper motors in full, 1/2, 1/4, 1/8, 1/16 and 1/32-step modes. This driver module is generally used in Robotics, ATMs and Gaming Machines.
Reviews
There are no reviews yet.