Description
Resistor 2.0W 5% (10pcs)
Resistor 2.0W 5% (10pcs)
$0.45
Additional information
| Resistor 2W 5% | 10 Ω, 15 Ω, 20 Ω, 22 Ω, 30 Ω, 33 Ω, 39 Ω, 47 Ω, 51 Ω, 68 Ω, 100 Ω, 220 Ω, 330 Ω, 470 Ω, 1 KΩ, 2.2 KΩ, 3 KΩ, 4.7 KΩ, 10 KΩ, 100 KΩ, 470 KΩ, 510 KΩ |
|---|
Related products
-
Out of Stock
$3.00CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
-
$5.00The RC522 is a 13.56MHz RFID module that is based on the MFRC522 controller from NXP semiconductors. The module can supports I2C, SPI and UART and normally is shipped with a RFID card and key fob. It is commonly used in attendance systems and other person/object identification applications.
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$6.00 – $8.50Arduino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator (CSTCE16M0V53-R0), a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your Uno without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.
Select options This product has multiple variants. The options may be chosen on the product page
Reviews
There are no reviews yet.