Description
PH 2.0mm Wire Cable Connector Single Head Female 10CM
PH 2.0mm Wire Cable Connector Single Head Female 10CM
$0.19 – $1.03
Additional information
| PH 2.0mm | 2pins, 3pins, 4pins, 5pins, 6pins, 7pins, 8pins, 9pins, 10pins, 12pins |
|---|
Related products
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$3.00The A4988 is a complete Microstepping Motor Driver with built-in translator for easy operation. The driver has a maximum output capacity of 35 V and ± 2 A. It can operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes.
Select options This product has multiple variants. The options may be chosen on the product page -
Select options This product has multiple variants. The options may be chosen on the product page Quick View$3.00 – $3.50These shield is made by L293D driver chip. It is very easy for plug with Arduino or ESP to drive any DC motor for Robot or RC Car.
Select options This product has multiple variants. The options may be chosen on the product page -
Out of Stock
$3.00CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
Reviews
There are no reviews yet.