-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$0.75 – $2.00GT2 Rubber Timing Belt Close Loop Width 6mm
Select options This product has multiple variants. The options may be chosen on the product page -
-
-
$1.25Specifications: Input: USB-C female or + and – solder terminals Input voltage: 4.35-6V (recommended voltage 5V) Charge cut-off voltage: 4.2V + / – 1% (charges a 1S Lithium Ion Polymer Battery) Maximum charging current output: 1000mA Battery overcharge protection voltage: 4.3V Battery discharge protection voltage: 2.4V Battery over-current protection current: […]
-
-
$3.00Description 3 strings of 12.6V 20A lithium battery protection board (with function – AUTO ) of application: lithium batteries with a nominal voltage of 3.6V and 3.7V (including 18650, 26650, and polymer lithium batteries) Continuous discharge current (upper limit): 20A (if the heat dissipation environment is not good, reduce the […]
-
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$0.30Potentiometer Linear WH148 15mm
Select options This product has multiple variants. The options may be chosen on the product page -
Select options This product has multiple variants. The options may be chosen on the product page Quick View$0.19 – $1.03SH 1.0mm Wire Cable Connector Single Head Female 10CM
Select options This product has multiple variants. The options may be chosen on the product page -
$1.50Items Description Digital Light intensity detection module: GY-30 The ROHM genuine BH1750FVI chip Power supply :3-5v Illumination range :0-65535 lx The sensor built 16bitAD converter Direct digital output, complex calculation is omitted, omitting calibration Does not distinguish between ambient light Close to the visual sensitivity of the spectral characteristics 1 […]
-
$1.50The MAX7219/MAX7221 are compact, serial input/output common-cathode display drivers that interface microprocessors (µPs) to 7-segment numeric LED displays of up to 8 digits, bar-graph displays, or 64 individual LEDs. Included on-chip are a BCD code-B decoder, multiplex scan circuitry, segment and digit drivers, and an 8×8 static RAM that stores […]
-
$1.00Vibration Sensor Module Vibration Switch SW-420 is based on the vibration sensor SW-420 and Comparator LM393 to detect if there is any vibration that beyond the threshold. The threshold can be adjusted by the on-board potentiometer. When this no vibration, this module output logic LOW the signal indicates LED light, […]
-
$2.50MQ-3 Gas Sensor Module detects the presence and amount of alcohol / ethanol present in the air. MQ-3 module is suitable for detecting Alcohol, Benzine, CH4, Hexane, LPG, CO. Sensitive material of MQ-3 gas sensor is SnO2, which with lower conductivity in clean air. When the target alcohol gas exist, […]
-
$7.00MAX6675 Module Thermocouple Sensor This MAX6675 Module K Type Thermocouple Sensor Measure 1024°C Temperature sensor makes use of the Maxim MAX6675 K-Thermocouple to digital converter IC to provide a microcontroller compatible digital serial interface (SPI compatible) for giving an accurate temperature compensated measurement of the supplied K-Type thermocouple sensor. It […]
-
$1.25Description:TCRT5000 sensors constantly emit infrared infrared emitting diodes, infrared rays emitted when reflected or not reflected but the intensity is not big enough, the infrared receiver has been in the off state, then the output of the module is low, indicating diode remains off state; when the object appeared to […]
-
-
$3.00ADC Bit rate: 16 Bit Interface Type: I2C Channels: 4 Channel AN0 AN1 AN2 AN3 or 2 differential inputs Input voltage: 2.0-5.5v Channel input voltage :0-VDD Continuous Mode: Only 150μA Single-Shot Mode: Auto Shut-Down PROGRAMMABLE DATA RATE:8sps-860sps Input range programmed control, 7 types input ranges: -0.256V ~ + 0.256V, -0.512V […]
-
-
-
Select options This product has multiple variants. The options may be chosen on the product page Quick View$3.00XB Aluminum Heavy Duty Coupling L25 W20
Select options This product has multiple variants. The options may be chosen on the product page
Concept
Bridge Cable Robot
Cable Inspection Robot is a research project by ArrowDot Company with function to check the quality of cable for bridge which can be used for Neak Loeung Bridge, New Balay Bridge and planned Koh Pich-Koh Norea Bridge. This robot equipped with analyzed camera that can view the cracked point and the vibration level of the cable. Last but not least, this robot can be remote and live up to 500m wirelessly.
