Wireless and IoT
-
-
$3.00ADC Bit rate: 16 Bit Interface Type: I2C Channels: 4 Channel AN0 AN1 AN2 AN3 or 2 differential inputs Input voltage: 2.0-5.5v Channel input voltage :0-VDD Continuous Mode: Only 150μA Single-Shot Mode: Auto Shut-Down PROGRAMMABLE DATA RATE:8sps-860sps Input range programmed control, 7 types input ranges: -0.256V ~ + 0.256V, -0.512V […]
-
$2.5017 Keys DC 5V-24V RF Wireless Remote LED Controller Remote for SMD 3528, 5050 RGB Strip Light
-
$0.403pcs LDR 5mm GL5528 Light Dependent Resistor A Light Dependent Resistor (LDR) is also called a photoresistor or a cadmium sulfide (CdS) cell. It is also called a photoconductor. It is basically a photocell that works on the principle of photoconductivity. The passive component is basically a resistor whose resistance […]
-
-
-
-
-
-
-
$3.00ABS Plastic Case For Raspberry Pi 3 Model B+ Official Case From Raspberry Pi without Cooling Fans
-
$3.00ABS Plastic Case For Raspberry Pi 4 Model B Official Case From Raspberry Pi without Cooling Fans
-
Out of Stock
$23.00The Arduino Due is a microcontroller board based on the Atmel SAM3X8E ARM Cortex-M3 CPU. It is the first Arduino board based on a 32-bit ARM core microcontroller. It has 54 digital input/output pins (of which 12 can be used as PWM outputs), 12 analog inputs, 4 UARTs (hardware serial ports), a 84 MHz clock, an USB OTG capable connection, 2 DAC (digital to analog), 2 TWI, a power jack, an SPI header, a JTAG header, a reset button and an erase button.
-
-18% Off
$23.00Arduino kit startup learning kit LED 7 segment Motor DC Stepper Motor Ultrasonic LDR Joystick Buzzer LCD Button Pot 10K Resistor IC Chip Water Sensor Battery Holder
-
Out of Stock
$5.00The LilyPad Arduino is designed for e-textiles and wearables projects. It can be sewn to fabric and similarly mounted power supplies, sensors and actuators with conductive thread.
-
$15.00 – $16.50The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Mega 2560 board is compatible with most shields designed for the Uno and the former boards Duemilanove or Diecimila.