DC-DC Adjustable Step Up Converter Module 10-60V to 12-85V 600W 15A

Related products

• 

  Add to wishlist

  Select options This product has multiple variants. The options may be chosen on the product page Quick View

  Arduino UNO R3

  $6.00 – $8.50

  Arduino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator (CSTCE16M0V53-R0), a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your Uno without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

  Select options This product has multiple variants. The options may be chosen on the product page

• Out of Stock

  Add to wishlist

  Read more Quick View

  CNC Shield V3

  $3.00

  CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.

  Read more

• Out of Stock

  Add to wishlist

  Read more Quick View

  LCD OLED 0.96″ White 7pins

  $6.00

  The OLED displays are one of the most attractive displays available for a microcontroller. It has a good view angle and pixel density which makes it reliable for displaying small level graphics. Interfacing this IC with MCU can either be done using IIC or using SPI hence helps to save some pins as well.

  So if you are looking for a slim, attractive and efficient display module to make your project look cool with graphics then this module might be the right choice for you.

  Read more

• 

  Add to wishlist

  Select options This product has multiple variants. The options may be chosen on the product page Quick View

  HC-Bluetooth

  $6.00 – $7.50

  Each Model of HC Bluetooth is very popular for using with any Microcontroller such as Arduino or STM. Bluetooth is easy for you to control wirelessly any device in short rang via your Phone or Computer. Bluetooth model of HC have communication protocol UART.

  Select options This product has multiple variants. The options may be chosen on the product page