Description
FTDI Basic Breakout USB to TTL 6 Pins Module FT232RL FTDI USB MWC Programmer for Arduino
FTDI Basic Breakout USB to TTL 6 Pins Module FT232RL FTDI USB MWC Programmer for Arduino
$4.50
Available on backorder
Related products
-
Out of Stock
$3.00CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
-
$3.00The CNC Shield v4 is made for the control of 3D printers, milling and engraving machines. This version of the shield has 1 motor driver less than its predecessor, but is more compact and has room for an Arduino Nano. This board has 3 sockets for the installation of stepper motor drivers such as the A4988. Only 2 channels per motor are required to control this motor. There is also a connection for 2 end-stop switches per motor.
-
Out of Stock
$6.00Module is used where short distance wireless communication is needed. The module is used for wireless communications of less than 100 meters. The module is preferred where power consumption is issue. HM-10 MODULE is designed by BLE chip so it consumes very less power to function. So the module can be used on mobile systems. The module uses UART communication and so it can be interfaced with almost all controllers or processors.
Available on backorder
Reviews
There are no reviews yet.