CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
HC-12 wireless serial port communication module is a new-generation multichannel embedded wireless data transmission module. Its wireless working frequency band is 433.4-473.0MHz, multiple channels can be set, with the stepping of 400 KHz, and there are totally 100 channels. The maximum transmitting power of module is 100mW (20dBm), the receiving […]
The CNC Shield v4 is made for the control of 3D printers, milling and engraving machines. This version of the shield has 1 motor driver less than its predecessor, but is more compact and has room for an Arduino Nano. This board has 3 sockets for the installation of stepper motor drivers such as the A4988. Only 2 channels per motor are required to control this motor. There is also a connection for 2 end-stop switches per motor.
The LilyPad Arduino is designed for e-textiles and wearables projects. It can be sewn to fabric and similarly mounted power supplies, sensors and actuators with conductive thread.
Reviews
There are no reviews yet.