SIM800A_ Nano development board is a high-performance industrial-grade GSM/GPRS module with a rich interface, perfect function, stable operation, strong anti-interference, high integration of peripheral circuits and small size. It is especially suitable for various fields that require voice/SMS/GPRS data services, such as smart home, intelligent collection system, remote monitoring and so on.
Features:
Support dual-band GSM/GPRS (900MHz / 1800MHz)
Support RS232/TTL serial port (supports 3. 3V/5V system)
Support 5V- 18V power supply (9V1A power supply is recommended)
Reserved voice interface
Reserve SMA and IPX interfaces
Support SMS service MT/M0/Text/PDU mode
Support TCP/UDP communication, FTP/HTTP service
Support Nano SIM card
Pin description:
PWR: Positive power supply
DTR: DTR
RI: RI output pin
RES: reset foot
M+: Mic+
M-: Mic-
S+: horn positive
S-: horn negative
GND: power ground
BAT: Lithium battery power supply interface
EN: Power enable, default high
VCC_IN: external power input
TXD: TTL serial output
RXD: TTL serial input
V_MCU: Level matching interface
R_232: RS232 serial input
T_232: RS232 serial output
SIM800A Chip:
Main Characteristics:
Two-frequency 900/1800MHz
GPRS multi-slot class 12/10
GPRS m0bile station class B
Meet the GSM 2/2+ standard
– Class 4 (2W @900MHz)
– Class 1 (1W @1800MHz)
Size: 24*24*3mm
Controlled by AT c0mmands (GSM 07.07, 07.05 and SIMCOM enhanced AT c0mmand set)
Supply voltage: 3.4 ~ 4.4V
Low power consumption
Operating temperature: -40°C ~ +85°C
Data Transmission:
GPRS class 12: Maximum 85.6 kbps (downstream rate)
Module is used where short distance wireless communication is needed. The module is used for wireless communications of less than 100 meters. The module is preferred where power consumption is issue. HM-10 MODULE is designed by BLE chip so it consumes very less power to function. So the module can be used on mobile systems. The module uses UART communication and so it can be interfaced with almost all controllers or processors.
The A4988 is a complete Microstepping Motor Driver with built-in translator for easy operation. The driver has a maximum output capacity of 35 V and ± 2 A. It can operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes.
CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
HC-12 wireless serial port communication module is a new-generation multichannel embedded wireless data transmission module. Its wireless working frequency band is 433.4-473.0MHz, multiple channels can be set, with the stepping of 400 KHz, and there are totally 100 channels. The maximum transmitting power of module is 100mW (20dBm), the receiving […]
Reviews
There are no reviews yet.