Hall Current Sensor CJMCU-758 Linear Current Sensor Output Voltage Proportional AC or DC Current
Working voltage: 3 -5V (MAX 8 V)
Static output voltage: VCC/2
Working current: 13.5mA (MAX)
Storage temperature range: -65°C -165°C
The maximum output current (VIOUT-GND): 3mA
Internal bandwidth: 120KHz
Module size: 37mm * 18mm
Industry-leading noise performance through patented amplifier and filter design processes
Integrated shielding significantly reduces current conductor-to-wafer capacitive coupling due to high dV/dt signals and prevents bias drift in high-end, high-voltage applications.
Improve total output error rate by temperature gain and offset adjustment
Small package size for easy installation
High reliability monolithic Hall IC
Ultra low power loss: internal conduction resistance 100 μΩ
Insulation design enables economical high-end current sensing in high voltage systems
Meets AEC Q-100 standards
3.0 to 5.5V, single supply operation
120 kHz typical bandwidth
Corresponding to the step input current, the output rise time is 3 μs
Output voltage is proportional to AC or DC current
Calibrated at the factory to ensure accuracy
Extremely stable output offset voltage
Near zero hysteresis
The relationship between voltage output and current input:
VOUT = VOUT(Q) + Vsens x I
VOUT(Q) is the static output voltage, which is VCC/2, which is the output voltage when there is no input. Vsens is a sensor-sensitive scale, also known as a coefficient. I is the current flowing from IP+ to IP-.
For example, suppose the sensor model is 050B, VCC is 5V, and“I” current is 10A, then the output is 5V / 2 + 40mV / A x 10A = 2.9V.
Module is used where short distance wireless communication is needed. The module is used for wireless communications of less than 100 meters. The module is preferred where power consumption is issue. HM-10 MODULE is designed by BLE chip so it consumes very less power to function. So the module can be used on mobile systems. The module uses UART communication and so it can be interfaced with almost all controllers or processors.
CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.
HC-12 wireless serial port communication module is a new-generation multichannel embedded wireless data transmission module. Its wireless working frequency band is 433.4-473.0MHz, multiple channels can be set, with the stepping of 400 KHz, and there are totally 100 channels. The maximum transmitting power of module is 100mW (20dBm), the receiving […]