Reparp Mendel Ramps 1.5 Motherboard Mega Shield For DIY 3D Printer

Related products

• Out of Stock

  Add to wishlist

  Read more Quick View

  CNC Shield V3

  $3.00

  CNC Shield V3.0 can be used as drive expansion board for engraving machine, 3D printer and other devices. There’re 4 slots in the board for stepper motor drive modules, can drive 4 stepper motors, and each step stepper motor only need two IO port, that is to say, 6 IO ports can quite well to manage three stepper motor, it’s very convenient to use. After insert Arduino CNC Shield V3.0 into Arduino UNO, and installed GRBL firmware then you can quickly DIY a CNC engraving machine.

  Read more

• 

  Add to wishlist

  Select options This product has multiple variants. The options may be chosen on the product page Quick View

  L293D Motor Shield

  $3.00 – $3.50

  These shield is made by L293D driver chip. It is very easy for plug with Arduino or ESP to drive any DC motor for Robot or RC Car.

  Select options This product has multiple variants. The options may be chosen on the product page

  Controller Type

  Choose an optionL293D for ArduinoL293D for ESP8266 Clear

• 

  Add to wishlist

  Select options This product has multiple variants. The options may be chosen on the product page Quick View

  Arduino UNO R3

  $6.00 – $8.50

  Arduino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator (CSTCE16M0V53-R0), a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your Uno without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

  Select options This product has multiple variants. The options may be chosen on the product page

• 

  Add to wishlist

  Select options This product has multiple variants. The options may be chosen on the product page Quick View

  Arduino MEGA 2560

  $15.00 – $16.50

  The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Mega 2560 board is compatible with most shields designed for the Uno and the former boards Duemilanove or Diecimila.

  Select options This product has multiple variants. The options may be chosen on the product page