Through the potentiometer adjusting soil moisture threshold control, automatic in garden, garden automatic watering, family flowerpot soil humidity control, all kinds of electronic games, with high power relay, can control large current device, less than setting humidity automatic start relay, greater than setting humidity automatically disconnect and delay function, without delay of critical humidity state relay don’t stop flicker problem solving is a simple and practical soil humidity control system.
1. Using the company’s production of high-quality soil sensor for detection of soil moisture, and the surface of the nickel plating, widening of the sensing area can improve conductive properties, prevent soil contact is easy to rust, prolong service life;
2. The product can be a wide range of control soil humidity and control the corresponding threshold value by adjusting the potentiometer and the humidity is lower than set value, start relay, is higher than the set value, the relay is switched off.
3. Product with the function of time delay, delay 3-5 seconds when detected humidity in the critical state, relay will not blink, stroboscopic phenomenon;
4 products using high quality relay, can withstand the load of 1500W, to meet the requirements of most people;
5 products with power indicator and indicator relay;
Supply voltage: 12VDC input current: more than 100mA
Load: 10A 250V AC or 10A 30V DC (lower than the current in this range can be used)
1 sensors applied to the detection of soil moisture;
Module 2. Blue potentiometer is used to soil moisture threshold adjustment, clockwise adjustment and control the humidity will be bigger, counterclockwise smaller;
3 due to the module with delay function, adjust the humidity value, once every tune need to wait about 5-8 seconds, see the change of the relay, the green LED lamp also has the corresponding change, until adjusted to meet the requirements.
Module is used where short distance wireless communication is needed. The module is used for wireless communications of less than 100 meters. The module is preferred where power consumption is issue. HM-10 MODULE is designed by BLE chip so it consumes very less power to function. So the module can be used on mobile systems. The module uses UART communication and so it can be interfaced with almost all controllers or processors.
Each Model of HC Bluetooth is very popular for using with any Microcontroller such as Arduino or STM. Bluetooth is easy for you to control wirelessly any device in short rang via your Phone or Computer. Bluetooth model of HC have communication protocol UART.
The CNC Shield v4 is made for the control of 3D printers, milling and engraving machines. This version of the shield has 1 motor driver less than its predecessor, but is more compact and has room for an Arduino Nano. This board has 3 sockets for the installation of stepper motor drivers such as the A4988. Only 2 channels per motor are required to control this motor. There is also a connection for 2 end-stop switches per motor.